How to Install A SATA Hard Drive

Installing a Serial ATA hard disk drive is generally easier than an IDE drive, as it is not necessary to configure jumpers. While physically installing the hard drive in the machine is similar, the SATA drives require fewer configurations and planning. The hard drive has jumpers at the rear of the drive, but they are used for power management and have nothing to do with Master, Slave and Cable Select like the IDE drives use.

Just like any hard drive, there are some precautions you must take when handling a new drive. Before doing anything, read the manufacturer's directions and follow any special instructions that might have been shipped with the HDD.

SATA HDD precautions

• Turn off and unplug the computer.
• Wear an anti-static wrist band or make sure you are properly grounded.
• Do not put stickers or labels on the drive.
• Do not touch the electronics on the hard drive.

Installation process

You can mount the SATA drive in the computer any way you want (flat, upright, and upside down) provided you use the screw mounts on the side or top of the drive. Mount the drive where you will have good air flow and be sure to use the SATA cable that ships with the drive or one that is less than 39 inches, which is within the SATA specification. You can connect the serial cable to a SATA controller on the motherboard, or a controller card if the motherboard does not have an on-board SATA controller.

Next, connect power to the drive using the SATA power connector or the legacy Molex connector. Do not use both at the same time, as this could hurt the hard drive.
SATA hard drive is better than IDE drives both in power consumption and speed. So when next you want to build new computer, consider installing a SATA drive.

For more information on hardware’s and question please comment on the post or send a mail to solutionprovider2000@gmail.com or visit http://online-computer-repairs.blogspot.com. You can subscribe to my feed and stay current with more computer repair articles